What Should I Do When The Excavator Is Shaking

In this article, I will tell you how to do when the excavator is shaking?

There are two main reasons for machine rocking.

First of all, the ground is not flat. Second, the coordination of the operating machine is not good.

Below I will share the treatment of this problem: 1. The machine does not stop. Novice friends may not pay attention or feel the machine. Is it stable? In fact, when there is a little stability, the machine will shake slightly. It is mainly reflected on uneven ground, the flat bottom is not visible on the hard bottom, and on the concrete floor, you may think that the ground is flat. The operation does not sway. In fact, at the same level, concrete floors are more prone to sway than soil. The specific reason is that the cement road surface is too hard and has no buffer. Solution: Trim the machine and level the floor. Usually, which side of the soil is grounded. After the block is completed, lift the arm and let it down easily. If you think the machine doesn't look unstable, it will prove that it is flat. If there is a corner, it will have a little dirt.

The problem of motion coordination is the most critical reason. Motion coordination is the basis of all operations and the most important reason for machine swing. The specific manifestation of non-coordination is that the role is incoherent and the coherence is decomposed. For example, when a person is on Earth, an action action is performed. Solution: The way to improve coordination of movement is to improve coherence. This is simple, but it is difficult and difficult for novice friends. Before practicing coherence, you must clearly know which pole corresponds to which action, subconscious. Know which pole and which pole you want to play. On this basis, the consistency of the exercise is much simpler. The specific operation is to perform multiple actions simultaneously during the operation, which is also called a composite action. For example, in the bauxite mining process, the intermediate arm is first used with the boom bucket. After the soil is full, lift the boom and rotate. When the position of the bauxite point is about to open, open the stick to open the bucket. When the dirt in the bucket is about to be completed, it will rotate backwards. In the process, you first need to know where the next bucket is, then adjust the arms, buckets and boom before reaching that position. These operations are done during the revolving process and you can dig directly after the digging point. Connect all actions and let the machine stop. This is coordination. The more actions, the more stable the machine!